Dryer Vent Cleaning in Temple City, CA

Frequently Asked Questions

My dryer is in the garage against the back wall — is that short run even worth cleaning?

Yes, and it's usually the easiest job we do in Temple City. That classic 1950s–60s tract setup puts the dryer a few feet from a louvered hood on the stucco, so the duct itself rarely packs solid. The problem is the hood: it sits low on the wall, under mature camellias and street trees, and the louvers catch leaf litter and dropped blossoms from outside while lint pushes against them from inside. A short run with a blocked termination backs up just as badly as a long one. We clean the duct and clear the hood from the outside so the flaps actually swing again.

Our laundry is in a hall closet and vents up into the attic. What's different about that?

That vertical run to a roof jack is the other common layout here, and it's the one that hides problems. You can't see the duct, so lint buildup and a sagging or disconnected section in the attic go unnoticed until the dryer starts running long or the closet gets warm and humid. Roof terminations also collect tree debris and sometimes bird nesting material, and the cap screen can blind over. We clean from the dryer end and check airflow at the roof, instead of assuming the run is clear because the first few feet brush out easily.

What usually causes a dryer vent to fail in a house like mine?

A few things come up repeatedly in Temple City. Debris at the termination: leaf and blossom fall onto low garage-wall caps and roof jacks, and the dry inland air means that material stays light and gets drawn tight against screens and louvers. Crushed or kinked flex behind the dryer where the machine was pushed back against the garage wall. And on the two-story rebuilds that have gone up on the original tract lots, the second-floor laundry feeds a much longer attic run with extra elbows, and lint settles in the horizontal stretches long before it reaches the exterior.

How much does it cost?

The number depends on your layout. A garage dryer with a short run through stucco to a wall hood is at the simple end (easy access, one termination, quick job). A hall-closet unit going up through the attic to a roof jack takes longer because we work both ends and may need roof access. The second-floor laundries in the rebuilt two-story homes sit at the higher end, since those attic runs are long, often have several turns, and sometimes need a section opened up if we find a disconnect. We'll look at your setup and tell you where it lands before we start.